|9||SST KNURLING TOOL HOLDERS|
CONICAL KNURL HOLDERS
Conical holders are the best way to knurl on the face of a part. A special conical type knurl is required to provide correct tracking. Conical knurls produce a cleaner knurl pattern than cylindrical knurls when knurling on the end of a part. A carbide pin and hex wrench are included. Knurl is not included. Setup Procedure: Set the tool so the center is in line with the machine center within .005 or better. Move the tool toward the work until the knurl makes contact. Move in a small amount and jog the spindle. If the knurl pattern is too shallow, move in a small amount more. If it does not track correctly, shift the tool off-center a small amount (.005-.010") and try again.
SHANK CONICAL KNURL HOLDERS
Shank type conicals can roll to a small diameter because they do not have a hole for a knurl pin. This is a more complex solution, but sometimes it's the only one that will work.
|1-800-642-2024||LOCAL 508-755-5302||FAX firstname.lastname@example.org|